SANTEST_GYcAT位移传感器_物位传感器:SANTEST_GYCRP位移传感器_GYCRS位移传感器

更新时间：2026-09-17 15:46:06

SANTEST_GYcAT位移传感器_物位传感器

访问量：582
型号：GYcAT
品牌：SANTEST
SANTEST_GYcAT位移传感器_物位传感器
SANTEST_GYcAT-Shanghai Hangou Mechanical And Electrical Equipment Co。，Ltd
GYCAT是日本SANTEST公司生产的线性位移传感器，传感器行程：15mm~2500mm，高精度，高品质

Thanks to the Surface Mount Technology, the entire signal
processing electronics of GYcAT series is integrated into a
transducer head.
You can get a voltage or current analog signal proportional to a
magnet position only by applying a 24V dc power supply directly to
the transducer.
GYcAT series have alarm output and head is equipped with noise
cancellation functions.
Non-linearity < ±0.05%FS TYP
Resolution < 0.01%FS
Repeatability < ±0.01%FS
Temp drift 40ppm FS/°C
Voltage output 0-10V or 10-0V / (output current:Max.5mA, load:Min.2kΩ)
Current output 4-20m or 20-4mA / (load:Min.500Ω)
Alarm output Open collector　30V　0.1A
Power supply +24 (±2) VDC (100mA)
Frequency response Std 1kHz (depending on stroke) sampling
Admissible press. 35MPa (probe rod)
Operating Temp -20°C-+65°C
Storage Temp -40°C-+80°C
Vibration 6G (or 40Hz 2mmPP)
Shock 50G (2msec)
Protection IP65
The above mentioned accuracy applies to sensors with an effective stroke of 300mm or more.
Model No.

(1):Effective Stroke
15mm-2500mm
(2):Output
A:0-10V
B:4-20mA
C:others (bipolar etc)
(3):Direction of output
(toward probe tip)
D:output data increase
R:output data decrease
(4):Thread
M:M24xP1.0 (Standard)
N:M18xP1.5
U:3/4-16UNF
(5):Sensor rod diameter
blank:Φ10 (Standard)
8:Φ8
14:Φ13.8
(6):Cable connection
CN:Connector (Standard)
G*:Pigtail type
(*:Cable length [m], Standard:1.5m)
Connector:straight type
Connector:only counter connector is supplied. In case cable needed,specify cable length.
Dimensions
Connector type (Standard)

Material probe head:Al diecast, probe rod:SS304
Standard magnet:No.2P. Other magnets are available from Magnet Grouping [B].
The tip dead zone length (70mm) depends on the magnet or float type.
The length of the cable should be less than 10m in case of using the voltage output type
and 100m in case of using the current output type.
Connector:Sanwa SNW-1607-PCF (Material:zinc alloy fluoroplastic)
Applied cable diameter:Φ6.6-Φ7.5
Wire size:Less than 0.5mm2
Connection
1 DC24V
2 NC
3 0V
4 SIG COM
5 Voltage output
6 (Current output)
7 Alarm output
*Shield should be connected with 0V at user side.
SANTEST_GYCRP位移传感器_GYCRS位移传感器SANTEST-GYSE-A 线性位移传感器数显电子拉力机，橡胶拉力机，金属拉力机SANTEST日本SANTEST代理SANTEST-GYCAT4. GYKM-LT位移传感器_GYKM-LS位移传感器进口三洋超低温冰箱MDF-U73V低温冰箱

SANTEST_GYCRP位移传感器_GYCRS位移传感器

型号：GYCRP/GYCRS
品牌：SANTEST
SANTEST_GYCRP位移传感器_GYCRS位移传感器SANTEST_GYCRP-Shanghai Hangou Mechanical And Electrical Equipment Co。，Ltd
GYCRP/GYCRS是日本SANTEST公司生产的线性位移传感器，传感器行程：15mm~5200mm，高精度，高品质
GYcRS and GYcRP probe uses RS-422 differential line drivers
signal transmission of which advantage is the noise free transmission
with a simple interface.
In combination with GYDC-05 controller, GYcRS probe has
achieved high resolution of 1μｍ.
GYcRP probe is available for high temperature ambient (200°C) and
SRT (Shock Resistant Technology) options.
Specifications
Non-linearity < ±0.025%FS TYP
Resolution (anaoglue) (digital) 16bit (with GYHC) / Min.1μm (with DC05)
Repeatability < ±0.01%FS
Temp drift < ±20ppmFS/°C
Admissible press. 35MPa (probe rod)
Operating Temp -20°C-+80°C
Storage Temp -40°C-+80°C
Vibration 6G (40Hz2mmPP)
Shock 100G (2msec)
Protection IP65
Cable length 1.5m (Standard) (Option Max.200m)
The above mentioned accuracy applies to sensors with an effective stroke of 300mm or more.
Resolution depends on the controller combined.
Model No.

(1):Effective stroke
15mm-5200mm
(2):Thread
M:M24xP1.0 (Std)
N:M18xP1.5
U:3/4-16UNF
(3):Sensor rod diameter
blank:Φ10 (Standard)
8:Φ8
14:Φ13.8
(4):Cable connection
CN:Connector (Standard)
G*:Pigtail type
(*:Cable length [m], Standard:1.5m)
Combined controller
Analogue output type:GYHC, GYFC2
Digital output type:GYDC-05
With LED Display:GKS-01 (only GYcRS)
Dimensions

Material probe head:Al diecast, probe rod:SS304
(GYcRP probe) Standard magnet:No.2P Other magnets are available from Magnet Grouping [B].
(GYcRS probe) Standard magnet:No.2PN Other magnets are available from Magnet Grouping [GG].
The tip dead zone length (70mm) depends on the magnet or float type.
Connector:Sanwa SNW-1607-PCF (Material:zinc alloy fluoroplastic)
In case of using probe only,
probe outputs digital signals (start/stop) using RS422 differential
line drivers. In response to user's interrogation (start) pulse, probe
provides stop pulse.