 |
产品型号： | GYKM-LT_GYKM-LS |
| 产品品牌： | SANTEST | |
| 产品价格： | 1200元/台 | |
| 所 在 地： | 上海 普陀区 | |
| 发布日期： | 2015-02-24 | |
 |
||
详细说明
SANTEST_GYKM-LT位移传感器_GYKM-LS位移传感器SANTEST_GYKM-LT-Shanghai Hangou Mechanical And Electrical Equipment Co。，Ltd
GYLT/GYLS是日本SANTEST公司生产的线性位移传感器，传感器行程：15mm~3500mm，高精度，高品质，销售热线：021-51085161 SANTEST_GYKM-LT_GYKM-LS Shanghai Hangou Mechanical And Electrical Equipment Co。，Ltd
Low cost, all-in-one, direct analogue output (4-20mA or 0-10V).
Absolute, non-contacting transducer
Improved non-linearity, improved S/N ratio, reduced power
consumption.
Easy to connect. (screw type)
Wide temperature operating range.
Shock and vibration resistant.
Specifications
Non-linearity < ±0.025%FS TYP
Resolution < 0.01%FS
Repeatability < ±0.01%FS
Temp drift < 40ppm FS/°C
Voltage output Model:GYLS 0-10V or 10-0V / (output current:Max.5mA, load:Min.2kΩ)
Current output Model:GYLT 4-20mA or 20-4mA / (load:Min.500Ω)
Power Supply +24 (±2) VDC (50mA)
Frequency response Std 1kHz (depending on stroke) sampling
Admissible press. 35MPa (probe rod)
Operating Temp -20°C-+80°C
Storage Temp -40°C-+80°C
Vibration 6G (or 40Hz 2mmPP)
Shock 50G (2msec)
Protection IP67 (10kPa, 30min)
The above mentioned accuracy applies to sensors with an effective stroke of 300mm or more.
Model No.
(1):Effective stroke
15mm-3500mm
(2):Direction of output
(toward probe tip)
D:output data increase
R:output data decrease
(3):Thread
M:M24xP1.0 (Standard)
N:M18xP1.5
U:3/4-16UNF
(4):Sensor rod diameter
blank:Φ10 (Standard)
8:Φ8
14:Φ13.8
(5):Cable connection
CN:Connector (Standard)
G*:Pigtail type
(*:Cable length [m], Standard:1.5m)
Connector:straight or angle type
Connector:only counter connector is supplied. In case cable needed,
specify cable length.
Dimensions
Material probe head:Al diecast, probe rod:SS304
Standard magnet:No.2PN. Other magnets are available from Magnet Grouping [GG].
The tip dead zone length (70mm) depends on the magnet or float type.
The length of the cable should be less than 10m in case of using the voltage output type
and 100m in case of using the current output type.
Connector:Omron XS2C-D4S1 (straight type) or D4S2 (L type) (Material:PBT plastic)
Applied cable diameter:Φ5-Φ6
Wire size:0.18-0.75mm2
Connection
1 DC24V
2 0V
3 Output (Current or Voltage)
4 COM
*Shield should be connected with 0V
at user side.
*0V and COM are connected in the head.